Headrest Hat and Helmet Holder
The Kamchatka Gear Headrest Hat and Helmet Holder—let’s call it the HHHH for short—straps onto your vehicle’s headrest and keeps your hats and helmets out of the way yet within reach. It features an easy-to-release and easy-to-reattach magnetic buckle. As long as your hat or helmet has some sort of loop or hole large enough for the roughly 1-inch-wide holding loop to go through, it should fit on the HHHH.
How many hats and helmets can the HHHH hold? That’s tricky to answer due to the sheer variety of hat and helmet sizes out there, but it will hold a lot. I’ve tested it with up to 8 baseball caps and a climbing helmet, and I still could have fit more on there! I’ve also successfully tested it with two helmets, but your mileage may vary there due to vastly differing sizes of helmets.
The HHHH is adjustable and should fit any traditional headrest. If you’re unsure, whip out a flexible tape measure and measure around the headrest longitudinally. If the measurement is less than 24 inches, the HHHH will fit on your headrest.
To attach the HHHH to your headrest, unclip the side release buckle, wrap the holder vertically around the headrest, and re-clip the side release buckle (see accompanying photos). The hat holding loop is meant to be positioned at the top of either the front or back of the headrest, whichever you prefer for your purposes. (When the holding loop is positioned on the back side of the headrest, it will not interfere with a passenger’s head on the front side.) Tighten the HHHH by pulling the free end of webbing until the HHHH holds snugly onto the headrest, and tuck any excess webbing away using the webbing keeper clip. To release the magnetic buckle, press the center button with the index finger while holding onto the sides of the buckle with the thumb and middle finger. Load your hats/helmets onto the holding loop and then reattach the two sides of the magnetic clip.
Made in the USA
Fit: This product will ft any headrest that is less than 24 inches around longitudinally. It will not fit headrests that are a non-adjustable extension of the seat back itself (like this).
Weight: 1 ounce (29 grams)
Material: Heavy duty nylon webbing